低成本钢尾渣-矿渣基矿山充填料的优化开发

 为实现多固废协同利用、降低充填成本,在矿渣基全粒级细尾砂胶结充填料基础上,以流动性和抗压强度为表征,利用热闷钢渣磁选尾渣(钢尾渣)替代部分矿渣作为胶凝材料,脱硫灰和水泥熟料替代部分专用添加剂作为外加剂,采用正交试验探寻掺量规律,优化固体填充料配比,开发钢尾渣-矿渣基软性矿山充填料,并研究了外加剂与胶材比、灰砂比等因素的影响。对比分析了矿渣基准组、钢尾渣-矿渣基准组(B1)、强度最优外加剂组分钢尾渣-矿渣组(B7)等3组充填料的微观形貌及XRD图谱以探究其水化机理。结果表明,钢尾渣替代矿渣量增加、外加剂与胶材比减小,充填料浆流动性改善,但充填体抗压强度下降。强度正交试验结果表明,钢尾渣掺量大小决定强度低高,脱硫灰掺量宜高于水泥熟料。进一步调整外加剂组分配比,在灰砂比为1∶6、钢尾渣替代矿渣为20%条件下,找出B7组外加剂组分为脱硫灰、水泥熟料分别替代30%、20%专用添加剂,B7组料浆扩展度为143 mm,充填体形貌为富铁绿泥石胶结假方体钙硅灰石,28 d抗压强度达2.13 MPa,较基准组低0.19 MPa,较B1提高0.26 MPa。该替代方案满足现场充填C2级强度的要求,改善流动性并显著降低了充填成本。优化的外加剂组分配比在灰砂比为1∶4条件下同样具有强度优化作用,但较灰砂比为1∶6条件下低。     

含钛高炉渣制备CaTiO3-多孔地质聚合物光降解吸附材料

含钛高炉渣作为固体废弃物,国内存量巨大,且其中的钛组元难以提取,导致含钛高炉渣综合利用一直没有得到有效解决。针对当前含钛高炉渣利用率低、附加值低等问题,基于含钛高炉渣成分特点,通过选择性析晶(CaTiO₃优势析出)、碱激发,制备出CaTiO₃-多孔地质聚合物的复合材料。试验结果表明,析晶温度1 400 ℃、保温1 h能够促进CaTiO₃的优势析出,而剩余氧化物以玻璃相形式存在。制备出的CaTiO₃-多孔地质聚合物材料结合了CaTiO₃高光催化活性与多孔地质聚合物比表面积大的优点,对亚甲基蓝具有优异的吸附效果,最大吸附量可达60.4 mg/g。在投加量为50 mg,2 h吸附、3 h光降解条件下,对亚甲基蓝去除率可达94.5%,在治理有机污染领域有良好的应用前景。     

熔渣法碳化铬涂层的抗氧化性能研究

对熔渣法碳化铬涂层在各种温度下经20h和200h的氧化性能进行了研究，与常用的一些锅炉用钢进行了对比试验，结果表明碳化铬涂层抗氧化性能比15CrMo、102、T91钢好，可以与TP347钢相媲美。     

麻石烟气脱硫装置耐酸胶泥的研究

通过对用于麻石烟气脱硫装置的2^#和3^#耐酸胶泥的单因素对比试验的研究，得出2^#胶泥耐酸度较好，因而防腐蚀性能也较好。这不仅回收了固废，而且还具有可观的环境效益。     

复吹转炉“留渣 双渣”脱磷工艺试验

摘要：在国内某转炉钢厂采用“留渣 双渣”工艺技术进行脱磷工艺试验。结果表明：随着转炉前期脱磷率不断升高,终点脱磷率不断提高。铁水硅含量对前期脱磷率的影响最大。根据铁水成分,在冶炼前期适当降低供氧强度、降低气固氧比、加入适量石灰及烧结矿,均有利于前期脱磷率的提高。在一倒时每吨钢液加入4~8kg石灰,不影响出钢温度,可提高一倒-终点阶段脱磷率,同时可提高终点脱磷率。从终点的控制效果可知,终点炉渣碱度应保持不小于3.0,炉渣中FeO质量分数在16%~20%,并适当降低终点出钢温度在1610~1630℃,有利于终点脱磷率的提高。通过加强熔池搅拌,促进钢渣反应趋于平衡,有利于终点磷分配比提高,从而可进一步提高终点脱磷率。     

Evaluation of high Ni-Cr-Mo alloys for the construction of sulfur dioxide scrubber plants

Corrosion in wet lime/limestone systems used for flue gas desulfurization in thermal power plants is of great concern. The frequent variations in acidity and in chloride and fluoride ion concentrations experienced by such systems pose a serious threat to the materials of construction. Currently used materials mostly type 316L stainless steel often fail to meet their life expectancy. The present study evaluates the performance of advanced Ni- Cr- Mo alloys 59 and C- 276 in a simulated sulfur dioxide scrubber environment. Accelerated tests showed that high Ni- Cr- Mo alloys have little tendency to leach metal ions such as chromium, nickel, and molybdenum at different impressed potentials. Scanning electron microscopy was used to examine the morphology of pitting attack.     

防腐保温业务任重道远、大有可为

阐述了国内石油工业的现状与未来，对中国石油工程建设协会防腐保温技术专业委员会的工作提出了要求和建议。     

氰化氢在终冷塔中气液两相之间转移的研究

分析了煤气中氰化氢的形成,论述了氰化氢在煤气和其冷凝液中的平衡机理,讨论了影响氰化氢相平衡的因素,研究了直接终冷、间接终冷时煤气中氰化氢的转移情况。     

不同活化剂对石油焦基活性炭孔结构的影响

以石油焦为原料 ,Na OH,KOH和 Na2 CO3 为活化剂制备活性炭 ,采用氮气吸附考察了不同活化剂对活性炭的比表面积、中孔和微孔孔径分布、孔容积及平均孔径等孔结构的影响 .结果表明 :KOH活化制备的活性炭包含 1 nm的微孔和 4nm的中孔 ,总孔容 0 .648cm3 /g,比表面积大 ;Na OH制备的活性炭以 1 nm的微孔为主 ,占总孔容 ( 0 .1 65 cm3 /g)的 98% ,平均孔径 1 .83nm;Na2 CO3 制备的活性炭以 4nm的中孔为主 ,占总孔容 ( 0 .1 43cm3 /g)的 68.5 % ,平均孔径 3.42 nm,比表面积小 .3种样品的孔径都呈现出多峰分布特征 .KOH和 Na2 CO3 活化制备的活性炭的 N2 吸附脱附曲线属于 型 ,Na OH活化制备的活性炭吸附脱附曲线属于 型 .     

Some aspects of the role of coal thermoplasticity and coke structure in coal gasification. 2. The effects of pressure and heating rate on dilatometric parameters and optical anisotropy development

An examination of the influence of pressure and heating rate on the thermoplastic properties of a weakly coking coal and of coal with various pitch-like additives was carried out using a high pressure dilatometer. Pressure up to 4 MPa markedly increased the swelling properties and increased the plastic range by decreasing the softening temperature, but the effects of pressure were strongly influenced by rate of heating with high heating rates enhancing the effects. Additions of tar or pitch also enhanced swelling at low pressure. The solid carbonization residues from the dilatometer were examined by polarized light microscopy to determine the content and composition of optically anisotropic species. The anisotropic content was increased by increases in pressure and heating rate and pitch additives enhanced the anisotropic content, especially at low pressure, without affecting the composition of the anisotropy. No direct correlations exist between the dilatometric parameters and the optical anisotropy but their dependence on the conditions emphasizes that when considering high pressure gasification of coal, it is necessary to obtain data under appropriate conditions.